Softball Rule 1.10

Print

There is no moratorium on any type of bat in any level of Little League Softball. Below is the text of Softball Rule 1.10. It provides the specifications for bats in each of the various divisions of softball.

Rule 1.10

The bat must be a softball bat which meets Little League specifications and standards as noted in this rule. It shall be a smooth, rounded stick and made of wood or a material tested and proved acceptable to Little League standards.

The bat shall be no more than 33 inches (34 inches for Junior/Senior/Big League) in length, not more than two and one-quarter (2-1/4) inches in diameter, and if wood, not less than fifteen-sixteenth (15/16) inches in diameter (7/8 inch for bats less than 30 inches) at its smallest part. Bats may be taped or fitted with a sleeve for a distance not exceeding 16 inches from the small end. Colored bats are acceptable. A non-wood bat must have a grip of cork, tape or composition material, and must extend a minimum of 10 inches from the small end. Slippery tape or similar material is prohibited. An illegal or altered bat must be removed.

NOTE 1: The traditional batting donut is not permissible.
NOTE 2: The bat may carry the mark “Little League Tee Ball.”
NOTE 3: Non-wood bats may develop dents from time to time. Bats that can¬not pass through the approved Little League bat ring must be removed from play. The 2 ¼ inch bat ring must be used for bats in all softball divisions. Any bat that has been altered shall be removed from play.